Allied Telesis AT-S95 CLI - Manual (Page 72)

Page 60
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Example
The following example enables the device to use the Simple Network Time Protocol (SNTP) to request and accept
SNTP traffic from servers.
sntp unicast client poll
The sntp unicast client poll Global Configuration mode command enables polling for the Simple Network Time
Protocol (SNTP) predefined Unicast servers. Use the no form of this command to disable the polling for SNTP
client.
Syntax
sntp unicast client poll
no sntp unicast client poll
Default Configuration
Polling is disabled.
Command Mode
Global Configuration mode
User Guidelines
The sntp client poll timer Global Configuration mode command determines polling time.
Example
The following example enables polling for Simple Network Time Protocol (SNTP) predefined Unicast clients.
sntp server
The sntp server Global Configuration mode command configures the device to use the Simple Network Time
Protocol (SNTP) to request and accept SNTP traffic from a specified server. Use the no form of this command to
remove a server from the list of SNTP servers.
Syntax
sntp server {ip-address | hostname}[poll] [key keyid]
no sntp server host
Parameters
•
ip-address — IP address of the server.
• hostname — Hostname of the server. (Range: 1-158 characters)
• poll — Enable polling.
• keyid — Authentication key to use when sending packets to this peer.
(Range:1-4294967295)
Console(config)# sntp unicast client enable
Console(config)# sntp unicast client poll