Allied Telesis AT-S95 CLI - Manual (Page 280)

Page 268
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Syntax
show stack [unit unit]
Parameters
•
unit— Specifies the number of the unit. (Range: 1-6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command is not relevant to standalone devices.
Example
The following example displays stack status . .
Console> show stack
Unit
MAC Address Software Master Uplink Downlink Status
---- ----------------- -------- -------- ------ -------- ------
1 00:15:77:74:64:40 v1.1.0.23 Enabled 2 3 Master
2 00:15:77:66:3e:80 v1.1.0.23 Enabled 3 1 Backup
3 00:01:02:03:04:05 v1.1.0.23 Disabled 1 2 Slave
Topology is Ring
Unit
Unit Id After Reset
---- -------------
1 1
2 2
3 3
console# show stack 1
Unit: 1
MAC address: 00:15:77:74:64:40
Master: Enabled.
Product: AT -S94/48. Software: v1.1.0.23
Uplink unit: 2 Downlink unit: 3.
Status: Master
Active image: image-2.
Selected for next boot: image-2.