Allied Telesis AT-S95 CLI - Manual (Page 187)

Radius Commands
Page 175
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval during which the device waits
for a server host to reply. Use the no form of this command to return to the default configuration.
Syntax
radius-server timeout timeout
no radius-server timeout
Parameters
•
timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The timeout value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the timeout interval to 5 seconds.
radius-server deadtime
The radius-server deadtime Global Configuration mode command improves RADIUS response time when
servers are unavailable. The command is used to cause the unavailable servers to be skipped. Use the no form of
this command to return to the default configuration.
Syntax
radius-server deadtime deadtime
no radius-server deadtime
Parameters
•
deadtime — Length of time in minutes during which a RADIUS server is skipped over by transaction
requests. (Range: 0 - 2000)
Default Configuration
The deadtime setting is 0.
Command Mode
Global Configuration mode
Console(config)# radius-server timeout 5