Allied Telesis AT-S95 CLI - Manual (Page 100)

Page 88
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Example
In the following example, automatic crossover is enabled on port 1/g5.
back-pressure
The back-pressure Interface Configuration (Ethernet, port-channel) mode command enables back pressure on a
given interface. Use the no form of this command to disable back pressure.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In the following example back pressure is enabled on port 1/g5.
port jumbo-frame
The port jumbo-frame Global Configuration mode command enables jumbo frames for the device. Use the no
form of this command to disable it.
Syntax
port jumbo-frame
no port jumbo-frame
Default Configuration
Disabled.
Command Mode
Global Configuration mode.
Console(config)# interface ethernet 1/g5
Console(config-if)# mdix auto
Console(config)# interface ethernet 1/g5
Console(config-if)# back-pressure