Allied Telesis AT-S95 CLI - Manual (Page 169)

Power over Ethernet Commands
Page 157
Chapter 19.Power over Ethernet Commands
Note
The PoE commands are operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE
devices.
power inline
The port inline Interface Configuration (Ethernet) mode command configures the administrative mode of inline
power on an interface.
Syntax
power inline {auto | never}
Parameters
•
auto—Enables the device discovery protocol and, if found, supplies power to the device.
• never—Disables the device discovery protocol and stops supplying power to the device.
Default Configuration
The device discovery protocol is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables powered device discovery protocol on port 1/g1, so that power will be supplied to
a discovered device.
power inline powered-device
The power inline powered-device Interface Configuration (Ethernet) mode command adds a comment or
description of the powered device type to enable the user to remember what is attached to the interface. Use the
no form of this command to remove the description.
Syntax
power inline powered-device pd-type
Console(config)# interface ethernet 1/g1
Console(config-if)# power inline auto