Allied Telesis AT-S95 CLI - Manual (Page 288)

Page 276
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Chapter 29.User Interface Commands
enable
The enable User EXEC mode command enters the Privileged EXEC mode.
Syntax
enable [privilege-level]
Parameters
•
privilege-level — Privilege level to enter the system. (Range: 1 - 15)
Default Configuration
The default privilege level is 15.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enters Privileged EXEC mode:
disable
The disable Privileged EXEC mode command returns to the User EXEC mode.
Syntax
disable [privilege-level]
Parameters
•
privilege-level — Privilege level to enter the system. (Range: 1 - 15)
Default Configuration
The default privilege level is 1.
Console> enable
enter password:
Console#