Allied Telesis AT-S95 CLI - Manual (Page 278)

Page 266
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Command Mode
Global Configuration mode
User Guidelines
This command is not relevant to standalone devices.
The following algorithm is used to select a unit as the master:
• If only one master-enabled unit is in the stack (1 or 2), it becomes the master.
• If a unit configured as a forced master, it becomes the master.
If a forced master unit is removed from a stack and placed in a different stack with another forced master unit, both
are considered to be forced, and the election criteria continue as follows:
• The unit with the longer up-time is elected master. Units are considered to have the same up-time if they were
powered up within ten minutes of each other.
• If both forced master units have the same up-time, Unit 1 is elected.
Example
The following example selects Unit 2 as the stack master.
stack reload
Note
This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.
The stack reload Privileged EXEC mode command reloads stack members.
Syntax
stack reload [unit unit]
Parameters
•
unit— Number of the unit to be reloaded (Range: 1-6)
Default Configuration
All units are reloaded.
Command Modes
Privileged EXEC mode
User Guidelines
This command is not relevant to standalone devices.
If no unit is specified, all units are reloaded.
Console(config)# stack master unit 2