Allied Telesis AT-S95 CLI - Manual (Page 145)

Line Commands
Page 133
exec-timeout
The exec-timeout Line Configuration mode command sets the interval that the system waits until user input is
detected. Use the no form of this command to return to the default configuration.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
Parameters
•
minutes — Specifies the number of minutes. (Range: 0 - 65535)
• seconds — Specifies additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.
Example
The following example configures the interval that the system waits until user input is detected to 20 minutes.
history
The history Line Configuration mode command enables the command history function. Use the no form of this
command to disable the command history function.
Syntax
history
no history
Default Configuration
The command history function is enabled.
Command Mode
Line Configuration mode
User Guidelines
This command enables the command history function for a specified line. To enable or disable the command
history function for the current terminal session, use the terminal history user EXEC mode command.
Console(config)# line console
Console(config-line)# exec-timeout 20