Allied Telesis AT-S95 CLI - Manual (Page 56)

Page 44
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
show bridge address-table count
The show bridge address-table count Privileged EXEC mode command displays the number of addresses
present in the Forwarding Database.
Syntax
show bridge address-table count [vlan vlan][ ethernet interface-number | port-channel port-channel-number]
Parameters
•
vlan — Specifies a valid VLAN, such as VLAN 1.
• interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, the number of addresses present in all VLANs are displayed.
---- ----------------- ---- -----------------
1 00:60:70:4C:73:FF 1/g8 Permanent
1 00:60.70.8C.73:FF 1/g8 delete-on-timeout
200 00:10:0D:48:37:FF 1/g9 delete-on-reset
Console# show bridge address-table count
This may take some time.
Capacity: 8192
Free: 8190
Used: 2
Secure: 0
Dynamic: 2
Static : 0
Internal: 0