Allied Telesis AT-S95 CLI - Manual (Page 181)

QoS Commands
Page 169
Parameters
•
dscp-list — Specify up to 8 DSCP values, with each value separated by space.
• dp — Enter the Drop Precedence value to which the DSCP values corresponds. Possible values are 0 - 2
(Where 2 is the highest Drop Precedence).
Parameters Range
•
dscp-list — 0 - 63
• dp — 0 - 2
Default Configuration
All the DSCPs are mapped to Drop Precedence 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the System to basic mode and the trust state.
qos map dscp-queue
The qos map dscp-queue Global Configuration mode command modifies the DSCP to CoS map. Use the no
form of this command to return to the default map.
Syntax
qos map dscp-queue dscp-list to queue-id
no qos map dscp-queue
Parameters
•
dscp-list — Specifies up to 8 DSCP values separated by a space. (Range: 0 - 63)
• queue-id — Specifies the queue number to which the DSCP values are mapped.
Default Configuration
The following table describes the default map.
Console(config)# qos map dscp-dp 2 4 6 8 10 to 2
DSCP value Queue-ID
00-15 1
16-31 2
32-47 3
48-63 4