Allied Telesis AT-S95 CLI - Manual (Page 332)

Page 320
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
User Guidelines
The actual timeout can be determined by comparing the dot1x timeout server-timeout value and the result of
multiplying the radius-server retransmit value with the radius-server timeout value and selecting the lower of
the two values.
Example
The following example sets the time for the retransmission of packets to the authentication server to 3600
seconds.
show dot1x
The show dot1x Privileged EXEC mode command displays the 802.1X status of the device or specified interface.
Syntax
show dot1x [ethernet interface]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status of 802.1X-enabled Ethernet ports .
Console(config-if)# dot1x timeout server-timeout 3600
Console# show dot1x
802.1x is disabled
Port Admin Mode Oper Mode Reauth
Control Reauth
Period Username
---- ---------- --------- ------- ------ --------
1/g1 Auto Authorized Enabled 3600 Bob
1/g2 Auto Authorized Enabled 3600 John
1/g3 Auto Authorized Enabled 3600 Clark
1/g4 Auto Authorized Enabled 3600 Bill