HP XP Command View Advanced Edition Software - Manual (Page 98)

Command line interface commands
98
statusOfDBInconsistency=0
openAllocatedActualCapacity=1,038,504,240
openUnallocatedCapacity=355,420,800
openUnallocatedActualCapacity=355,420,800
openReservedCapacity=0
openReservedActualCapacity=0
numberOfReservedLUs=0
numberOfOpenReservedLUs=0
numberOfImReservedLUs=0
***** : The value is encoded by the CLI.
4-4-17-3 GetStorageArray (subtarget=ArrayGroup)
GetStorageArray (subtarget=ArrayGroup) obtains information about one or all array
groups in one or all storage subsystems (see parameters in Table 4-33 ).
A user to whom a user-defined resource group is assigned can obtain information about
array groups in the storage subsystems that the user is permitted to access.
Table 4-33 GetStorageArray (subtarget=ArrayGroup) command parameters
Parameter Name Status Description
model Optional Model of the storage subsystem
If you omit this parameter, you will obtain information about the models of
all storage subsystems.
serialnum Optional Serial number of the storage subsystem
If you omit this parameter, all the storage subsystems become the target.
subtarget Required Specify ArrayGroup.
objectid Optional Object ID of the array group in a storage subsystem
Specify this parameter when you want to obtain the information about a
specific array group. If you specify this parameter, you must also specify
the model and serialnum parameters.
When specifying the model and serialnum parameters without
specifying this parameter, the information about all array groups in the
specified storage subsystem is acquired. Specify the objectID obtained
from another CLI response. The value is encoded by the CLI.
arraygroupsubinf
o Optional Information obtained about an array group or groups
The values you can specify are LogicalUnit and PDEV. If you specify
multiple values at the same time, separate the values by commas.
lusubinfo Optional Information about a logical unit
The values you can specify are Path and LDEV. If you specify multiple
values at the same time, separate the values by commas.
If you specify this parameter, you must also specify
arraygroupsubinfo=LogicalUnit
.