HP XP Command View Advanced Edition Software - Manual (Page 46)

Command line interface commands
46
Table 4-1 describes which CLI commands can be used to find which parameter values.
Table 4-1 Extracting parameter values
To Find This
Parameter Value: Do This:
alertnum Execute the GetAlerts command. Use the value displayed as alert number
under An instance of Alerts.
arraygroupname Execute the GetStorageArray (subtarget=ArrayGroup) command,
specifying only the model and serialnum parameters, and ArrayGroup for
the subtarget parameter. Use the displayName value that appears
under An instance of ArrayGroup.
arraygroupobjid Execute the GetStorageArray (subtarget=ArrayGroup) command,
specifying only the model and serialnum parameters, and ArrayGroup for
the subtarget parameter. Use the array group displayed as objectID.
Specify the objectID obtained from another CLI response. The value is encoded
by the CLI.
chassis Execute the GetStorageArray (subtarget=ArrayGroup) command,
specifying only the model and serialnum parameters, and ArrayGroup for
the subtarget parameter. The chassis value appears in a StorageArray.
clprfilter Obtain this value from the execution result of the GetStorageArray
(subtarget=LDEV)
command. In the execution result of this command, the
clprNumber value appears under An instance of LDEV. Use this value to
specify the clprfilter parameter.
configfileid Execute the GetHost command without specifying the objectid, hostname,
configfileid
, or replicationgroupid parameter. Use the objectID
value that appears under An instance of ConfigFile.
controllername Execute the GetStorageArray (subtarget=PortController)
command, specifying only the model and serialnum parameters, and
PortController
for the subtarget parameter. Use the displayName
value that appears under An instance of PortController.
controllernum Execute the GetStorageArray (subtarget=PortController)
command, specifying only the model and serialnum parameters, and the
value for subtarget=PortController. Use the value specified as
controllerID
.
ctrlid Execute the GetStorageArray (subtarget=PortController)
command, specifying only the model and serialnum parameters, and
PortController
for the subtarget parameter. Use the value displayed as
controllerID .
devnum Obtain this value from the execution result of the GetStorageArray
(subtarget=LDEV) command. Execute this command by specifying only the
model
and serialnum parameters, and LDEV for the subtarget parameter.
In the execution result of this command, the devNum value of an LDEV appears
under An instance of LDEV. Use this devNum value to specify the devnums
parameter.
devnums Obtain this value from the execution result of the GetStorageArray
(subtarget=LogicalUnit, lusubinfo=LDEV)
command. Execute this
command by specifying only the model and serialnum parameters,
LogicalUnit
for the subtarget parameter, and LDEV for the lusubinfo
parameter. In the execution result of this command, the devNum value of
LogicalUnit
appears under An instance of LogicalUnit. Use this
devNum value to specify the devnums parameter.