9-3 deletereplication, Table 4-99 deletereplication command parameters – HP XP Command View Advanced Edition Software User Manual
Page 221

Command line interface commands
221
status=1
muNumber=-1
copyTrackSize=14
splitTime=-1
*****
: The values are encoded by the CLI.
4-9-3 DeleteReplication
DeleteReplication deletes copy pair information from a RAID Manager configuration definition file
and releases the copy pair from the storage subsystem (see parameters in
).
A user who has only View permission cannot execute this command. A user to whom user-defined
resource groups are assigned and who also has Modify permission can specify the allowed
resources. If resources that are not allowed are specified, an error occurs.
NOTE:
To delete a specific copy pair from a copy group, you must specify pvolserialnum,
pvoldevnum
, svolserialnum (or svolsequencenum), and svoldevnum. If you omit these
parameters, the system deletes all copy pairs in the specified copy group.
Table 4-99
DeleteReplication command parameters
Parameter Name
Status
Description
replicationgroup
id
Required
Specify the copy group number.
pvolserialnum
Optional
Specify the serial number of the storage subsystem that contains the
primary volume (P-VOL).
pvoldevnum
Optional
Specify the device number of P-VOL.
This parameter can be specified in decimal, and in colon-separated
hexadecimal. If you specify a hexadecimal number, for
XP12000/XP10000/SVS200, XP1024/XP128, and XP512/XP48, use
the xx:yy format, where xx is the CU number, and yy is the LDEV
number. For XP24000/XP20000, use the ww:xx:yy format, where ww
is the LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If you omit ww, the LDKC number is regarded as 0.
NOTE:
The execution results are output in decimal.
svolserialnum
Optional
Specify the serial number of the storage subsystem that contains the S-
VOL.
NOTE:
If you specify this parameter, specify either svolserialnum or
svolsequencenum
. Do not specify both parameters at the same time.
This might cause an error to occur.
svolsequencenum
Optional
Specify the sequence number of the storage subsystem that contains
the S-VOL.
NOTE:
If you specify this parameter, specify either svolserialnum or
svolsequencenum
. Do not specify both parameters at the same time.
This might cause an error to occur.
svoldevnum
Optional
Specify the device number of S-VOL.
This parameter can be specified in decimal, and in colon-separated
hexadecimal. If you specify a hexadecimal number, for
XP12000/XP10000/SVS200, XP1024/XP128, and XP512/XP48, use
the xx:yy format, where xx is the CU number, and yy is the LDEV
number. For XP24000/XP20000, use the ww:xx:yy format, where ww
is the LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If you omit ww, the LDKC number is regarded as 0.
NOTE:
The execution results are output in decimal.