HP XP Command View Advanced Edition Software - Manual (Page 195)

Command line interface commands
195
Table 4-85 GetHost command parameters
Parameter Name Status Description
configfileid Optional Object ID of the HORCM configuration definition file in the host
If you omit this parameter, the command acquires information about all
HORCM configuration definition files contained in the host. If you specify
this parameter, you must also specify the objectid parameter. Specify
the objectID obtained from another CLI response. The value is encoded
by the CLI.
replicationgroup
id Optional ID of the copy group related with the host (ReplicationGroup)
If you specify this parameter, you must specify the objectid and
configfileid
parameters.
hostfilter Optional Type of the host that acquires information
Omit this parameter when all hosts are the target.
To specify two or more values, separate them with semicolons (;).
You can specify the following values:
NORMAL , EXT_PORT, and MAINFRAME
NOTE: Do not specify the objectid and hostname parameters at the
same time, as this might cause an error to occur.
Command execution example 1: This example obtains the pair information defined in the RAID
Manager configuration definition file whose configFileID is CONFIGFILE.1.11 in the host
whose objectID is HOST.1.
hdvmcli GetHost -o "D:\logs\GetHost.log" "objectid=*****"
configFileID=CONFIGFILE.1.11
***** : The value is encoded by the CLI.
Command execution result 1:
RESPONSE:
An instance of Host
objectID=*****
name=toro2
ipAddress=192.168.32.63
capacityInKB=0
hostType=-1
List of 2 WWN elements:
An instance of WWN
WWN=00.99.66.33.88.55.22.77
nickname=Jane
An instance of WWN
WWN=11.44.77.22.55.88.33.66
nickname=Jone
List of 1 ConfigFile elements:
An instance of ConfigFile
objectID=*****
instanceNumber=11
controlledBy=Device Manager
portNumber=50000
valid=1
List of 1 ReplicationGroup elements:
An instance of ReplicationGroup
objectID=*****
replicationGroupID=3
groupName=HCMD_CG0003