6-8 deletelungroup, 6-9 deletewwn, Table 4-72 deletelungroup command parameters – HP XP Command View Advanced Edition Software User Manual
Page 182
Command line interface commands
182
Command execution example:
hdvmcli DeleteLun -o "D:\logs\XP1024 DeleteLun.log" "serialnum=10001"
"model=XP1024" "port=1" "domain=1" "devnum=1" "deletionoption=lusekeep"
Command execution result:
RESPONSE:
(Command completed; no data returned)
4-6-8 DeleteLunGroup
DeleteLunGroup
deletes a LUN groups allocated to ports on the target storage subsystem. Any
LUNs (paths) in the group are not deleted (see
). A WWN can be specified, and access is
removed for just that WWN.
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.
NOTE:
DeleteLunGroup is supported by XP512/XP48 storage subsystems only.
Table 4-72
DeleteLunGroup command parameters
Parameter Name Status
Description
serialnum
Required
Serial number of the LUN group's storage array
model
Required Model
of
the
LUN group's storage array
port
Optional
ID for the port of LUN group to be deleted
NOTE:
Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
portname
Optional
Port name for the LUN group to delete
NOTE:
Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
lungroupid
Required
Object ID of the LUN group to be deleted
Specify the objectID obtained from another CLI response. The value is
encoded by the CLI.
Command execution example:
hdvmcli DeleteLunGroup –o "D:\logs\XP512 DeleteLunGroup.log" "serialnum=10011"
"model=XP512" "port=19" "lungroupid=*****"
*****
: The value is encoded by the CLI.
Command execution result:
RESPONSE:
(Command completed; no data returned)
4-6-9 DeleteWWN
DeleteWWN
removes a WWN from a port (see
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.