HP XP Command View Advanced Edition Software - Manual (Page 67)

Command line interface commands
67
using logical devices that the user is permitted to access. If LDEVs that are not allowed are
specified, an error occurs.
Make sure that you back up the data before creating a LUSE volume, because the data stored in
the LDEV/LU to be connected might be lost during creation of the LUSE volume.
When you create a LUSE volume, specify a formatted LDEV. If you include an unformatted LDEV
during creation of the LUSE volume, the LUSE volume will not be recognized from the hosts.
NOTE: This function is not available for the XP512/XP48.
NOTE: When you add a LUSE volume with the luseoption parameter set, specify a LDEV in which
a path is set as the first LDEV. If a LDEV without a path set is specified as the first LDEV, an error
will occur.
NOTE: When a LUSE volume is added with the luseoption parameter set, the extended LUSE
volume might not be able to be recognized, based on the host. In this case, restart the host.
Table 4-17 AddLUSE command parameters
Parameter Name Status Description
serialnum Required Serial number of the storage array from which LUSE is added
model Required Model of the storage array from which the LUSE is added
devnums Required Comma-separated list of LDEV device numbers to create the LUSE
This parameter can be specified in decimal, and in colon-separated
hexadecimal. If you specify a hexadecimal number, for
XP12000/XP10000/SVS200, XP1024/XP128, and XP512/XP48, use the
xx:yy format, where xx is the CU number, and yy is the LDEV number.
For XP24000/XP20000, use the ww:xx:yy format, where ww is the LDKC
number, xx is the CU number, and yy is the LDEV number. ww is optional.
If you omit ww, the LDKC number is regarded as 0.
NOTE: The execution results are output in decimal.
luseoption Optional An option for adding a LUSE volume to a volume for which a path is set
The value you can specify is force only.
NOTE: For XP1024/XP128, the version of the DKC microcode must be
21-05-00/00 or later when this option is specified.
Command execution example:
hdvmcli AddLUSE -o "D:\logs\XP1024 AddLUSE.log" "serialnum=15001"
"model=XP1024" "devnums=1001,1002"
Command execution result:
RESPONSE:
An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)
.
List of 1 Lu elements:
An instance of LogicalUnit
objectID=*****
devNum=1,001
displayName=3:E9
emulation=OPEN-3
devCount=2
devType=
capacityInKB=4,806,720