HP XP Command View Advanced Edition Software - Manual (Page 210)

Command line interface commands
210
Table 4-96 AddConfigFileForReplication command parameters
Parameter Name Status Description
pvolportname Optional Port name in the HORCM configuration file that manages the P-VOL path
NOTE: If you specify this parameter, specify either pvolportid or
pvolportname . Do not specify both parameters at the same time. This
might cause an error to occur.
pvolpoolid Optional Specify the pool ID of the journal data to which the P-VOL belongs.
NOTE: You must specify this parameter when you are using method 2 or
3 with XP Continuous Access Journal Software.
NOTE: When you are using method 1, this parameter value is invalid
even if you specify a value.
svolarraytype Required Model of the storage subsystem that includes the S-VOL
svolserialnum Required Serial number of the storage subsystem that includes the S-VOL
svoldevnum Required Device number of the S-VOL
This parameter can be specified in decimal, and in colon-separated
hexadecimal. If you specify a hexadecimal number, for
XP12000/XP10000/SVS200, XP1024/XP128, and XP512/XP48, use the
xx:yy format, where xx is the CU number, and yy is the LDEV number.
For XP24000/XP20000, use the ww:xx:yy format, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number. ww is
optional. If you omit ww, the LDKC number is regarded as 0.
NOTE: The execution results are output in decimal
svolportid Optional Port number in the HORCM configuration file that manages the S-VOL
path
NOTE: If you specify this parameter, specify either svolportid or
svolportname . Do not specify both parameters at the same time. This
might cause an error to occur.
svolportname Optional Port name in the HORCM configuration file that manages the S-VOL path
NOTE: If you specify this parameter, specify either svolportid or
svolportname . Do not specify both parameters at the same time. This
might cause an error to occur.
svolpoolid Optional Specify the pool ID of the journal data to which the S-VOL belongs.
NOTE: You must specify this parameter when you are using method 2 or
3 with XP Continuous Access Journal Software.
NOTE: When you are using method 1, this parameter value is invalid
even if you specify a value.