HP XP Command View Advanced Edition Software - Manual (Page 216)

Command line interface commands
216
Table 4-97 AddReplication command parameters
Parameter Name Status Description
munum Optional Specify the MU number of the P-VOL.
This parameter can be specified only for XP Continuous Access Journal
Software.
NOTE: If this parameter is not specified, Device Manager automatically
specifies the value.
fencelevel Optional Specify the P-VOL fence level as follows (default = Never). The fence
level is ignored for XP Business Copy Software, XP Continuous Access
Asynchronous Software, XP Snapshot, and XP Continuous Access
Journal Software.
•
Never : If you specify Never, a host write request to P-VOL is not
rejected even though the MCU can change the status of an S-VOL
pair into the suspend status.
•
Data : If you specify Data, a host write request to P-VOL is rejected
when an update copy fails.
•
Status : If you specify Status (XP24000/XP20000,
XP12000/XP10000/SVS200, XP1024/XP128, and XP512/XP48
only), a host write request to P-VOL is rejected only when the MCU
cannot change the status of an S-VOL pair to the suspend status.
copytracksize Optional Specify a copy pace (number of tracks copied at one time during initial
copy), as an integer between 1 and 15.
The default value is 3 for the XP24000/XP20000,
XP12000/XP10000/SVS200, XP1024/XP128, and XP512/XP48.
pairoption Optional The following value can be specified only when
XP12000/XP10000/SVS200 is being used:
•
suspend : Creates a delta resync pair.
NOTE: This parameter can be specified only when XP Continuous
Access Journal Software is being used.