HP XP Command View Advanced Edition Software User Manual
Page 149

Command line interface commands
149
Table 4-52
ModifyPort command parameters
Parameter Name Status
Description
wwnnickname
Optional
(for
XP24000/
XP20000,
XP12000/
XP10000/
SVS200,
XP1024/
XP128)
The nickname for the WWN
To specify two or more WWN nicknames, separate them with commas.
The value specified for this parameter differs depending on whether wwn
is specified.
If wwn is specified:
Specify the new nickname for WWN.
If wwn is not specified:
Specify the nickname for the WWN that is used to provide security for
the host storage domain.
If you specify the wwn parameter and do not specify the wwnnickname
parameter, the WWN nickname will not be changed.
Paired wwn parameters and wwnnickname parameters must be specified
in the same sequence.
You can use the following characters:
A-Z a-z 0-9 ! # $ % & ' ( )
+ - . = @ [ ] ^ _ ` { } ~ (space)
NOTE:
A WWN nickname cannot begin or end with spaces.
The number of characters that can be used for a WWN nickname is as
follows:
•
XP24000/XP20000: 0-32 bytes
•
XP12000/XP10000/SVS200: 0-16 bytes
•
DKC microcode version 50-04-01 or later: 0-32 bytes
•
XP1024/128: 0-8 bytes
newwwnnickname
Optional
(for
XP24000/
XP20000,
XP12000/
XP10000/
SVS200,
XP1024/
XP128)
New nickname of the WWN
NOTE:
If you specify this parameter, you must also specify the domain or
nickname
parameter.
NOTE:
If you specify this parameter, you must also specify the wwn or
newwwnnickname
parameter. You must specify the same number of
values for each parameter.