HP XP Command View Advanced Edition Software - Manual (Page 143)

Command line interface commands
143
Format when the command is used to change the usage rate threshold of a THP pool:
hdvmcli [ URL] ModifyPool model=model serialnum=serial-number poolid=pool-ID
threshold= usage-rate-threshold-of-THP-pool
NOTE: When you use this command to expand a THP pool, the logical units specified to be used
as pool volumes must satisfy the conditions listed in 4-4-5 .
NOTE: You can change the usage rate threshold of a THP pool only if the status of the THP pool
is Normal and the usage rate is less than 95%. The new threshold value also must be larger than
the value that is currently set as the usage rate of the THP pool.
Table 4-51 ModifyPool command parameters
Parameter Name Status Description
model Required Model of the storage subsystem
serialnum Required Serial number of the storage subsystem
poolid Required Pool ID
Specify the pool ID of the THP pool that you plan to expand or whose
threshold you plan to change.
threshold Optional Usage rate threshold for the THP pool (%)
When you want to change the threshold, specify a multiple of 5 from 5 to
95.
NOTE: You must specify either one or both of the threshold and
adddevnums parameters.
adddevnums Optional Device number of the logical unit(s)
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the LDKC
number, xx is the CU number, and yy is the LDEV number. ww is optional.
If ww is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
NOTE: You must specify either one or both of the threshold and
adddevnums parameters.
Command execution example: In this example, the ModifyPool command expands the THP
pool whose pool ID is 0 (poolid: 0) in the storage subsystem (serialnum: 15065, model:
XP24000
).
hdvmcli ModifyPool -o "D:\logs\XP24000\ModifyPool.log" model=XP24000
serialnum=15065 poolid=0 adddevnums=00:09:43
Command execution result:
RESPONSE:
An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)
.
List of 1 Pool elements:
An instance of Pool
objectID=*****
name=Pool
poolFunction=5
poolID=0
controllerID=-1
poolType=32