HP XP Command View Advanced Edition Software - Manual (Page 191)

Command line interface commands
191
Table 4-81 AddHostInfo command parameters
Parameter Name Status Description
hostname Required Name of the HostInfo
The number of characters that can be used for a name is 1-50 bytes.
ipaddress Optional IPv4 IP address of the host
ipv6address Optional IPv6 IP address of the host
mountpoint Optional Mount point on the host file system corresponding to the path
port Optional Port that the path is on
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
portname Optional Port name that the path is on
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
domain Required Domain ID of the path
This parameter can be specified in decimal and hexadecimal. If you
specify a hexadecimal number, add the 0x prefix.
NOTE: The execution results are output in decimal.
devnum Required Device number of the path
This parameter can be specified in decimal, and in colon-separated
hexadecimal. If you specify a hexadecimal number, for
XP12000/XP10000/SVS200, XP1024/XP128, and XP512/XP48, use the
xx:yy format, where xx is the CU number, and yy is the LDEV number.
For XP24000/XP20000, use the ww:xx:yy format, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number. ww is
optional. If you omit ww, the LDKC number is regarded as 0.
NOTE: The execution results are output in decimal.
osscsibus Required Host SCSI bus number
osscsiid Required Virtualized host SCSI ID
oslun Required Virtualized host LUN
portwwn Optional Port WWN on the host bus adapter
filetype Optional Type of the file system
filename Optional Name of the file system
size Optional LUN size in MB
percentused Optional Percent of the LUN in use
In this example, the CLI command specifies the following information for the host that connects to a
LUN (device number: 2, port number: 7, domain ID: 0) in a storage subsystem (serial number:
10001
, model: XP1024):
•
HostInfo record name: MY_HOSTINFO_XP1024
•
Host IP address: 172.16.64.159
•
Mount point: C:
•
File system type: NTFS
•
File name: C:
•
SCSI bus number: 0