HP XP Command View Advanced Edition Software - Manual (Page 48)

Command line interface commands
48
Table 4-1 Extracting parameter values
To Find This
Parameter Value: Do This:
munum Obtain this value from the execution result of the GetHost command. In the
execution result of this command, the muNumber value appears under An
instance of ReplicationInfo
. Use this value to specify the munum
parameter.
nickname Execute the GetStorageArray (subtarget=Port) command, specifying
only the model and serialnum parameters, Port for the subtarget
parameter, and HostStorageDomain for the portsubinfo parameter. The
nickname
value is displayed under An instance of
HostStorageDomain .
objectid Obtain this value from the execution result of the GetLogicalGroup
command. In the execution result of this command, the objectID value
appears under An instance of LogicalGroup. Use this objectID value
to specify the objectid parameter.
parent Obtain this value from the execution result of the GetLogicalGroup
command. In the execution result of this command, the parentID value
appears under An instance of LogicalGroup. Use this value to specify
the parent parameter.
parentpath Obtain this value from the execution result of the GetLogicalGroup
command. In the execution result of this command, the logicalPath value
appears under An instance of LogicalGroup. Use this value to specify
the parentpath parameter.
pdevid Obtain this value from the execution result of the GetStorageArray
(subtarget=PDEV) command. Execute this command by specifying only the
model and serialnum parameters, and PDEV for the subtarget parameter. The
information about all the PDEVs in the specified storage subsystem will be
returned. In the execution result of this command, use the pdevid value that
appears under An instance of PDEV to specify the pdevid parameter. If a
comma is included in the pdevid value, specify the value, excluding the comma.
poolfunction Obtain this value from the execution result of the GetStorageArray
(subtarget=JournalPool) command. In the execution result of this
command, the poolFunction value appears under An instance of
JournalPool
. Use this value to specify poolfunction parameter.
poolid Obtain this value from the execution result of the GetStorageArray
(subtarget=JournalPool) command. In the execution result of this
command, the poolID value appears under An instance of
JournalPool
. Use this value to specify the domainnickname poolid
parameter.
port Execute the GetStorageArray (subtarget=Port) command, specifying
only the model and serialnum parameters, and the value for
subtarget=Port
. The portID value appears under An instance of
Port .
portname Execute the GetStorageArray (subtarget=Port) command, specifying
only the model and serialnum parameters, and Port for the subtarget
parameter. Use the displayName value that appears under An
instance of Port.
pvoldevnum Execute the GetHost command, and then obtain the value from the execution
result.