HP XP Command View Advanced Edition Software - Manual (Page 62)

Command line interface commands
62
Table 4-15 AddHostStorageDomain command parameters
Parameter Name Status Description
•
Sequent
•
HP
•
Solaris
•
Netware
•
Windows
•
Windows Extension
•
Tru64
•
HI-UX
•
AIX
•
OPEN-VMS
The following value relies on the DKC microcode version.
For 21-05-00-XX/XX or later:
•
Windows Extension
•
Solaris Extension
For 21-14-02-XX/XXor later:
•
Standard Extension2
•
HP Extension2
•
Solaris Extension2
•
Windows Extension2
hostModeOption Optional
(for
XP24000/
XP20000
and
XP12000/
XP10000/
SVS200) An option of the host connection mode
To specify two or more options, separate them with semicolons (;).
For details about the values that you can specify, see Table 4-54 .
model Required Model of the storage array for the host storage domain
port Optional Port ID of the host storage domain (a specific array must be specified by
serial number and model)
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
portname Optional The port name for the host storage domain (specific arrays need to be
specified by serial number and model)
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
name Optional Name of the host storage domain
The number of characters that can be used for a name is 1-64 bytes.
NOTE: Spaces at the beginning or end of a name are not registered.
nickname Optional
(for
XP24000/
XP20000,
XP12000/ Nickname of the host storage domain
You can use the following characters:
A-Z a-z 0-9 ! # $ % & ' ( )
+ - . = @ [ ] ^ _ ` { } ~ (space)