6-14 modifylungroup, Table 4-78 modifylungroup command parameters – HP XP Command View Advanced Edition Software User Manual
Page 187

Command line interface commands
187
Command execution result:
RESPONSE:
(Command completed; no data returned)
4-6-14 ModifyLunGroup
ModifyLunGroup
modifies a LUN group assigned to a port of the target storage array
(XP512/XP48 subsystem only) and adds paths in the LUN group (see
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.
NOTE:
ModifyLunGroup is supported by XP512/XP48 storage subsystems only.
Table 4-78
ModifyLunGroup command parameters
Parameter Name Status
Description
serialnum
Required
Serial number of the storage array in which the LUN group exists
model
Required
Model of the storage array in which the LUN group exists
port
Optional
Port number of the LUN group
NOTE:
Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
portname
Optional
Port name of the LUN group
NOTE:
Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
objectid
Required
Object ID of the LUN group
Specify the objectID obtained from another CLI response. The value is
encoded by the CLI.
groupelements
Required
Comma-separated list of one or more object IDs of the paths to be added
to the LUN group
Specify the comma-delimited objectIDs obtained from another CLI
response
The values are encoded by the CLI.
nickname
Optional
Unique nickname of the LUN group
You can use the following characters:
A-Z a-z 0-9 ! # $ % & ' ( )
+ - . = @ [ ] ^ _ ` { } ~
The number of characters that can be used for a nickname is 1-8 bytes.
Command execution example:
hdvmcli ModifyLunGroup -o "D:\logs\XP512 ModifyLunGroup.log" "serialnum=10001"
"model=XP512" "port=19" "groupelements=*****" "objectid=*****" "nickname=hp"
*****
: The values are encoded by the CLI.
Command execution result:
RESPONSE:
An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)
.