HP XP Command View Advanced Edition Software - Manual (Page 211)

Command line interface commands
211
Table 4-96 AddConfigFileForReplication command parameters
Parameter Name Status Description
replicationfunct
ion Optional Type of copy used for the copy pair
•
BusinessCopy : Execute XP Business Copy Software.
•
ContinuousAccessSync : Execute XP Continuous Access
Synchronous Software.
•
ContinuousAccessAsync: Execute XP Continuous Access
Asynchronous Software.
•
Snapshot : Execute XP Snapshot.
•
ContinuousAccessJournal: Execute XP Continuous Access
Journal Software.
The default of this parameter differs depending on the condition as
shown below.
•
When the P-VOL and S-VOL exist in the same storage subsystem:
BusinessCopy
•
When the P-VOL and S-VOL exist in different storage subsystems:
ContinuousAccessAsync
(for XP24000/XP20000,
XP12000/XP10000/SVS200, XP512/XP48, XP1024/XP128)
munum Optional Specify the MU number of the P-VOL.
This parameter can be specified only for XP Continuous Access Journal
Software.
NOTE: For XP Continuous Access Journal Software, if this parameter is
not specified, the MU number of the created HORCM configuration file for
XP RAID Manager is set to 1
NOTE: For XP Business Copy Software or XP Snapshot, the MU number
of the created HORCM configuration file for XP RAID Manager is set to
0
. For XP Continuous Access Software, the MU number of the HORCM
configuration file for XP RAID Manager is not set because the MU
number is not necessary for XP Continuous Access Software.
pairoption Optional Specify this parameter to create the configuration of the 3DC delta
resync.
You can specify suspend only.
NOTE: This parameter can be specified only when XP Continuous
Access Journal Software is being used.
NOTE: To operate a specific copy pair in a copy group, you must specify all of the
pvolserialnum , pvoldevnum, svolserialnum (or svolsequencenum), and svoldevnum
parameters. If you omit all of these parameters, all the copy pairs in the copy group will be
changed.
You can use this function in one of three ways.
Method 1: The first method adds a copy pair definition to an existing copy group that is specified in
the RAID Manager configuration definition file, using the following command:
hdvmcli [URL] AddConfigFileForReplication [option] groupname=copy-group-
name pvolhostid=host-ID pvolinstancenum=instance-number svolhostid=host-
ID svolinstancenum=instance-number pvolarraytype=model
pvolserialnum=serial-number pvoldevnum=device-number [pvolportid=port-
number|pvolportname=port-name] svolarraytype=model svolserialnum=serial-
number svoldevnum=device-number [svolportid=port-
number|svolportname=port-name]
[replicationfunction={BusinessCopy|ContinuousAccessSync|ContinuousAccessA
sync|Snapshot|ContinuousAccessJournal}] [munum= Mu-number]