HP XP Command View Advanced Edition Software - Manual (Page 174)

Command line interface commands
174
scsiID=15
LUN=120
wwnSecurityValidity=true
***** : The value is encoded by the CLI.
4-6-2 AddLunGroup
AddLunGroup adds a LUN group to a port on the target storage subsystem. The path from the host
is set for the LUN group added to the port (see Table 4-66 ).
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.
NOTE: AddLunGroup is supported by XP512/XP48 storage subsystems only.
Table 4-66 AddLunGroup command parameters
Parameter Name Status Description
serialnum Required Serial number of the target storage array to which the LUN group is added
model Required Model of the target storage array to which the LUN group is added
port Optional Port number of the LUN group
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
portname Optional Port name of the LUN group
NOTE: Specify either port or portname. Do not specify both parameters
at the same time. This might cause an error to occur.
groupelements Required Comma-separated list of one or more object IDs of the paths to be added
to the LUN group
Specify the comma-delimited objectIDs obtained from another CLI
response. The values are encoded by the CLI.
nickname Required Unique nickname of the LUN group
You can use the following characters:
A-Z a-z 0-9 ! # $ % & ' ( )
+ - . = @ [ ] ^ _ ` { } ~
The number of characters that can be used for a nickname is 1-8 bytes.
name Optional The name given to the LUN group
The number of characters that can be used for a name is 1-64 bytes.
NOTE: Spaces at the beginning or end of a name are not registered.
Command execution example:
hdvmcli AddLunGroup -o "D:\logs\XP512 AddLunGroup.log" "serialnum=10001"
"model=XP512" "port=19" "groupelements=*****" "nickname=hp" "name=hp"
***** : The value is encoded by the CLI.
Command execution result:
RESPONSE:
An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)