HP XP Command View Advanced Edition Software - Manual (Page 185)

Command line interface commands
185
Table 4-75 DeleteWWNForLun command parameters
Parameter Name Status Description
port Optional Port number
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
portname Optional Port name
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
domain Required Domain ID of the path
This parameter can be specified in decimal and hexadecimal. If you
specify a hexadecimal number, add the 0x prefix.
NOTE: The execution results are output in decimal.
devnum Required Device number used to identify the path
This parameter can be specified in decimal, and in colon-separated
hexadecimal. If you specify a hexadecimal number, use the xx:yy
format, where xx is the CU number, and yy is the LDEV number.
NOTE: The execution results are output in decimal.
wwn Required Comma-separated list of WWNs for which path security is to be removed
Command execution example:
hdvmcli DeleteWwnForLun -o "D:\logs\XP512 AddWwnForLun.log" "serialnum=10001"
"model=XP512" "port=16" "devnum=16" "domain=0" "wwn=11.55.77.99.33.00.22.66"
Command execution result:
RESPONSE:
(Command completed; no data returned)
4-6-12 DeleteWWNForLunGroup
DeleteWWNForLunGroup removes one or more WWN(s) from a LUN group (XP512/XP48
subsystem only) (see Table 4-76 ).
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.
NOTE: DeleteWWNForLunGroup is supported by XP512/XP48 storage subsystems only.
Table 4-76 DeleteWWNForLunGroup command parameters
Parameter Name Status Description
serialnum Required Serial number of the storage array in which the LUN group exists
model Required Model of the storage array in which the LUN group exists
port Optional Port number of the LUN group
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.