HP XP Command View Advanced Edition Software User Manual
Page 278
Command line interface commands
278
4-11-3-1 When the target storage subsystem is other than
XP24000/XP20000, or is an XP24000/XP20000 whose microcode
version is earlier than 60-02-00-00/00
If an error occurs during the batch functionality execution, perform the following procedure to check
up to what point the batch file contents were processed. For the unprocessed commands, re-create
the batch file, and re-execute the batch functionality.
To check the batch file contents:
1.
Execute the AddStorageArray command or RefreshStorageArrays command.
The path information from the host to the volume is updated.
2.
Execute the GetStorageArray command to check which command lines in the batch file
were applied to the storage subsystem.
NOTE:
The command processing during batch functionality execution is not performed in the
order described in the batch file. All lines need to be checked to determine which command lines
in the batch file were applied.
3.
Delete the command lines applied to the storage subsystem from the batch file.
4.
Execute the batch functionality again.
4-11-3-2 When the target storage subsystem is an XP24000/XP20000 whose
microcode version is 60-02-00-00/00 or later
If an error occurs in the Device Manager server during batch functionality execution, the error
message of Device Manager CLI is output as follows:
ERROR RESPONSE:
KAIC90083-E Device Manager Server Exception:
error code=
code
error level=
level
error source=
source
description=
description
Check the Device Manager server error code that is output in place of code and the storage
subsystem error code that is output in place of description, and then take one of the following
actions:
When the error code of the Device Manager server is other than 6400:
Perform the following procedure:
1.
Execute the GetStorageArray command to check whether there is an error in the batch file.
2.
Correct any error in the batch file.
3.
Execute the batch functionality again.
When the error code of the Device Manager server is 6400:
Take the appropriate action according to the storage subsystem error code shown in
.