HP XP Command View Advanced Edition Software - Manual (Page 188)

Command line interface commands
188
List of 1 Port elements:
An instance of Port
.
. (Attributes of Port are omitted here)
.
List of 1 LUNGroup elements:
An instance of LUNGroup
objectID=*****
nickname=hp
List of 2 Path elements:
An instance of Path
objectID=*****
devNum=0
portID=19
domainID=16
scsiID=15
LUN=8
wwnSecurityValidity=true
.
. (repeated for other Path instances)
. .
***** : The values are encoded by the CLI.
4-6-15 ModifyWWNGroup
ModifyWWNGroup modifies a WWN group assigned to a target storage array port (XP512/XP48
subsystem only) and adds two or more WWNs to the WWN group (see Table 4-79 ).
A maximum of 127 WWN groups can be set for a port. Only the existing WWNs already used for the
port can be changed. You cannot change a WWN that belongs to a different WWN group or to a
different LUN or LUN group.
A user who has only View permission cannot execute this command. A user to whom a user-defined
resource group is assigned, and who also has Modify permission, can execute this command for
any resources.
NOTE: ModifyWWNGroup is supported by XP512/XP48 storage subsystems only.
Table 4-79 ModifyWWNGroup command parameters
Parameter Name Status Description
serialnum Required Serial number of the storage array in which the WWN group exists
model Required Model of the storage array in which the WWN group exists
port Optional Port number of the WWN group
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
portname Optional Port name of the WWN group
NOTE: Specify either port or portname. Do not specify both
parameters at the same time. This might cause an error to occur.
objectid Required Object ID of the WWN group
Specify the objectID obtained from another CLI response. The value
is encoded by the CLI.
wwn Required Comma-separated list of WWNs to be added to the WWN group