GW Instek PEL-3000 Series User Manual - Manual (Page 95)

OPERATION
93
program chains.
 Program chains need not be executed in order.
 There are 16 steps to a program.
 There are up to 16 programs to a chain.
PROGRAM 1
STEP 01
STEP 02
:
STEP 16
PROGRAM 2
STEP 01
STEP 02
:
STEP 16
PROGRAM 3
STEP 01
STEP 02
:
STEP 16
Setting Overview A program contains the following settings for
each step:
 Memory: the memory location of the load
operation for the selected step (M001~M256).
 Run: Designates the run setting for the step
(Auto, Manual, Skip).
 On-Time: Sets the run time of the test.
 Off-Time: Sets the off time between steps.
 P/F-Time: Sets the testing pass/fail delay time
for GoNo Go testing.
 Short-Time: Sets the shorting time for the step, if
any.