GW Instek PEL-3000 Series User Manual - Manual (Page 162)

PEL-3000 User Manual
160
Interface Configuration
Configure to USB Remote Interface
USB
configuration
PC side
connector
Type A, host
PEL-3000 side
connector
Rear panel Type B, slave
Speed
2.0 (full speed)
USB Class
USB CDC ACM
Note
Before USB can be used for remote control, it is
necessary to install the PEL-3000 USB device
driver, located on the accompanying User Manual
CD.
Operation 1. Connect the USB cable to the rear panel USB B
port.
2. Press
Shift
+
Utility
Help > Interface[F3] and set
the Interface setting to USB.
Configure GPIB Interface
To use GPIB, the optional GPIB port must be installed. See page 177
for installation details.
Operation 1. Ensure the PEL-3000 is off before proceeding.