GW Instek PEL-3000 Series User Manual - Manual (Page 94)

PEL-3000 User Manual
92
Program
The PEL-3000 can create programs that are designed to step-
through up to 16 pre-set load operations. The program function is a
powerful tool that can allow you to perform a number of different
operations in succession.
 The execution time of each step is user-defined.
 Programs can be chained together to make larger programs.
 Up to 16 programs can be created for a program chain.
See page 119 for saving load operations.
Program Overview
Description When you run a program, you are essentially
executing up to 16 different load operations
consecutively. Each of the different load
operations are ―steps‖ in the program. A
program starts at step 01 and ends at step 16.
 A program recalls the operating mode, range,
static/dynamic mode, response speed and other
settings of each step from stored memory. It also
recalls the Go-NoGo settings.
 The same memory settings can be used for
multiple steps.
 The execution time of each step is configurable.
 Applies the Go-NoGo settings for each step.
 Each step must be executed in order.
 Each step can be configured to automatically go
to the next step or wait for confirmation from
the user before proceeding to the next step.
 Individual steps can be skipped.
 Programs can be linked together to make