GW Instek PEL-3000 Series User Manual - Manual (Page 136)

PEL-3000 User Manual
134
Analog Control
The Analog Control subsection describes how to use the J1 Frame
Control Connector for voltage or resistance control. The J2
connector, located under the J1 connector is used for parallel
control. See page 181 for the details J1 and J2 connectors.
J1 Connector Overview
Description The J1 External Control Connector is a standard
Mil 20 pin connector (OMRON XG4A IDC
plug). The connector is used for all analog
control. The pins are used to determine what
mode is used.
See the appendix on page 181 to view the
contact pin assignment of the J1 connector.
WARNING
Some pins on the frame control connector have
the same potential as the front and rear terminals.
To prevent electric shock, ensure that the cover for
both the J1 and J2 External Control connectors are
used when the connectors are not in use.
Pin Assignment
FRAME CONT
J 1
1
2
19
20