GW Instek PEL-3000 Series User Manual - Manual (Page 57)

OPERATION
55
CR Units
Description The CR setting units can be set to ohm (Ω) or
millisiemens (mS).
Operation 1. Make sure the load is off.
2. Press Main
> Configure[F5] > Other[F2] and
set the CR Unit setting.
Range: Ω, mS
CV Mode
Description In Constant Voltage Mode, the unit will
maintain a constant voltage. In CV mode you
set the constant voltage level. For more details
on CV mode, see the appendix on page 190.
Warning
If you change the mode or the range when the load
is already on, the load will be turned off
automatically.
Operation 1. Make sure the load is off.
2. Press Main .
3. Select CV mode with the Mode[F1] soft-key.
4. Select the current range with the I Range[F2]
soft-key.
Range: High, Middle, Low
5. Select the voltage range with the V Range[F3]
soft-key.
Range: High, Low