GW Instek PEL-3000 Series User Manual - Manual (Page 118)

PEL-3000 User Manual
116
2. Press Insert Point[F1] to add a step to the
sequence.
 Every-time Insert Point is pressed the Step
parameter is incremented.
 The newly inserted ―point‖ becomes the active
step.
3. Set the following parameters for the currently
selected step. See page 115 for configuration
details.
 Value
 TRIG OUT
4. If you wish to edit a previously added
point/step, use the Steps parameter.
 Steps can only be selected after they have
already been added.
Steps 0001 ~ 1000(RPTSTEP)
5. The currently selected step can be deleted using
the Delete Point[F2] function.
 There cannot be less than 3 steps for fast
sequences.
Fill Function Press FILL[F4] to use the fill function. Set the fill
parameters:
 Start_Value
 End_Value
 Start_Step
 End_Step
The fill function can be used any number of
times.