GW Instek PEL-3000 Series User Manual - Manual (Page 35)

GETTING STARTED
33
Using the Front Panel Input Terminals
Description The front panel input terminals feature
polarity-distinct caps and accept M6 sized
crimped terminals.
Caution
The front panel input terminals on the PEL-3000
are physically connected to the rear panel
terminals.
Steps 1. Turn the power off from the rear panel or put
the unit into standby mode.
2. Turn the power off from the DUT.
3. Connect the load wires to the input terminals:
 Connect the positive (+) input terminal on the
load generator to the high potential output of
the DUT.
 Connect the negative (-) input terminal to the
low potential output of the DUT.
+ potential
- potential
Negative
terminal
Positive
terminal