GW Instek PEL-3000 Series User Manual - Manual (Page 163)

REMOTE CONTROL
161
2. Connect a GPIB cable from a GPIB controller to
the GPIB port on the PEL-3000.
3. Turn the PEL-3000 on.
4. Press
Shift
+
Utility
Help > Interface[F3] and set
the Interface setting to GPIB.
5. Set the GPIB address.
GPIB address 0~30
GPIB constraints  Maximum 15 devices altogether, 20m cable length,
2m between each device
 Unique address assigned to each device
 At least 2/3 of the devices turned On
 No loop or parallel connection
Pin Assignment
1 12
13 24
Pin Signal Pin Signal
1~4 Data I/O 1~4 13~16 Data I/O 5~8
5 EOI 17 REN
6 DAV 18 Ground (DAV)
7 NRFD 19 Ground (NRFD)
8 NDAC 20 Ground (NDAC)
9 IFC 21 Ground (IFC)
10 SRQ 22 Ground (SRQ)
11 ATN 23 Ground (ATN)
12 SHIELD Ground 24 Single GND