GW Instek PEL-3000 Series User Manual - Manual (Page 114)

PEL-3000 User Manual
112
Data Edit
Overview Each step in a fast sequence contains the
following setting parameters:
Setting Setting Range Description
Step 0001 ~ 1000 Selects/displays the current
step in the sequence.
 The number of available
steps is dependent on the
number of steps added using
the Ins. Point[F1] functions.
 A minimum of 3 steps.
Value The current or resistance
setting for the selected
operating mode.
TRIG OUT ON, OFF When TRIG OUT is set to
ON, a trigger signal is
output from the TRIG OUT
BNC terminal at the start of
the step. See page 150 for
details.
Time
amplitude
TRIG OUT = ON
TRIG OUT
Start of step
FILL Overview The FILL function is used to evenly step up the
current or resistance value settings from a
starting step to a finishing step.
The Fill Function can be used before or after
points are added to the fast sequence.
 Before: Will pre-fill each value within the fill
range when a new step is added.
 After: Will post-fill each value within the fill