GW Instek PEL-3000 Series User Manual - Manual (Page 164)

PEL-3000 User Manual
162
Configure RS232C
RS232C
Configuration Connector DB-9, Male
Baud Rate 2400, 4800, 9600, 19200, 38400
Stop Bit 1, 2
Parity None, Odd, Even
Operation 1. Connect an RS232C cable from the PC to the
rear panel RS232 port.
2. Press
Shift
+
Utility
Help > Interface[F3] and
set the Interface setting to RS232.
3. Set the Baud Rate, Stop Bit and Parity settings.
Pin Assignment 1 2 3 4 5
6 7 8 9
2: RxD (Receive data)
3: TxD (Transmit data)
5: GND
4, 6 ~ 9: No connection
PC Connection Use a null modem connection as shown in the
diagram below.
PEL - 3000 PC
RxD Pin 2 RxD Pin 2
GND Pin 5 GND Pin 5
TxD Pin 3 TxD Pin 3