GW Instek PEL-3000 Series User Manual - Manual (Page 109)

OPERATION
107
5. Set the following parameters for the currently
selected step. See the Data Edit Overview on
page 102 for configuration details.
 Value
 Time
 LOAD
 RAMP
 TRIG OUT
 PAUSE
6. If you wish to edit a previously inserted
point/step, use the Step parameter.
 Steps can only be selected after they have
already been inserted.
Steps 0001 ~ 1000
7. The currently selected step can be deleted using
the Delete Point[F2] function.
8. After all the steps for the sequence are
complete, press Save[F3] to save the steps.
Data Edit for Normal Sequence configuration is
complete.
 Go to Timing Edit for Normal Sequences to edit
the sequence. Page 104.
 Go to Running a Normal Sequence to run the
normal sequence. Page 108.