GW Instek PEL-3000 Series User Manual - Manual (Page 29)

GETTING STARTED
27
Power Up and Self Test
Steps 1. Insert the AC power cord into the power
socket.
2. Turn the external
power switch on.
(O → —)
3. If the unit doesn’t turn on, press the
On/Standby key.
 The ON/STBY key will go from standby (red)
to on (green).
4. The unit will show the splash screen and then
load the settings from when the unit was last
powered down.
Note
If the PEL-3000 fails to start up properly or does
not turn on, please see you local distributor.