GW Instek PEL-3000 Series User Manual - Manual (Page 59)

OPERATION
57
Warning
If you change the mode or the range when the load
is already on, the load will be turned off
automatically.
Operation 1. Make sure the load is off.
2. Press Main .
3. Select CP mode with the Mode[F1] soft-key.
4. Select the current range with the I Range[F2]
soft-key.
Range: High, Middle, Low
5. Select the voltage range with the V Range[F3]
soft-key.
Range: High, Low
6. Set the power level parameters using the scroll
wheel and number pad.
 For Static mode, set CP A Value and/or CP B
Value.
 For Dynamic mode, set Level1 and Level2.
 The maximum and minimum power levels
depend on the selected current range.
 For static mode, the parameter that is set last
becomes the ―active‖ setting. This will be shown
in the Operation Status Panel.
7. To add CV mode to CP mode (CP+CV), see
page 58.
8. Set the remaining basic configuration settings
such as the slew rate, and timer settings. See
page 63 for details.