GW Instek PEL-3000 Series User Manual - Manual (Page 184)

PEL-3000 User Manual
182
TRIG INPUT 11 When paused, clears the pause when a low level
TTL signal is applied for 10 μs or longer.
Pulled down the internal circuit to A COM using
approx. 50kΩ.
A COM 12 Connected to the negative load input terminal on
the rear panel.
LOAD ON
STATUS 13 Turns on when load is on. Open collector output by
a photocoupler.*4
RANGE STATUS 1 14 Range status output. Open collector output by a
photocoupler.*4 RANGE STATUS 0 15
ALARM STATUS 16 Turns on when an alarm (OVP, OCP, OPP, OHP,
RVP, or UVP) is activated or when an
external alarm is applied. Open collector output by
a photocoupler.*4
STATUS COM 17 STATUS signal common for pins 13 to 16.
N.C. 18
SHORT SIGNAL
OUT 19 Relay contact output (30 VDC/1 A)
SHORT SIGNAL
OUT 20
*1 Valid only when the front panel settings are
H range.
*2 RANGE CONT 0 RANGE CONT 1
H range 1 1
M range 1 0
L range 0 1
*3 RANGE STATUS 0 RANGE STATUS 1
H range OFF OFF
M range OFF ON
L range ON OFF
*4 The maximum applied voltage of the photocoupler
is 30 V; the maximum current is 8 mA.