GW Instek PEL-3000 Series User Manual - Manual (Page 180)

PEL-3000 User Manual
178
PEL-3000 Default Settings
The following default settings are the factory configuration settings
for the PEL-3000.
Main Settings
Item Panel Settings
Setup Memory Settings
(all 100 sets)
Current(CC) 0 A 0 A
Conductance(CR) 0 S 0 S
Voltage(CV) Maximum value Maximum value
Wattage(CP) 0 W 0 W
+CV OFF OFF
Current range H H
Voltage range 150 V 150 V
Load on/off Load off Load off
Operation mode CC CC
Slew rate
Maximum value of H
range Maximum value of H
range
Preset memories
Settings above in each
mode Settings above in each
mode
Main > Configure > Protection
Item Panel Settings
Setup Memory Settings
(all 100 sets)
OCP Level Maximum value Maximum value
OCP Setting LIMIT LIMIT
OPP Level Maximum value Maximum value
OPP Setting LIMIT LIMIT
UVP value OFF OFF
OVP value OFF OFF