GW Instek AFG-3000 Series - Manual (Page 98)

AFG-3000 Series User Manual
98
Selecting Sweep Mode
The Sweep button is used to output a sweep. If no
settings have been configured, the default settings
for output amplitude, offset and frequency are
used.
Setting Start and Stop Frequency
The start and stop frequencies define the upper and lower sweep
limits. The function generator will sweep from the start through to
the stop frequency and cycle back to the start frequency. The sweep
is phase continuous over the full range sweep range (100μHz-
80MHz: AFG-3081/50MHz: AFG-3051).
Panel Operation 1. Press the SWEEP key.
2. To select the start or stop
frequency, press F3 (Start)
or F4 (Stop).
~
3. The Start or Stop parameter will become
highlighted in the waveform display area.
Start
Stop