GW Instek AFG-3000 Series - Manual (Page 218)

AFG-3000 Series User Manual
218
OUTPut
Source Specific
Command
Description Enables/Disables or queries the front panel
output. The default is set to off.
Note If the output is overloaded by an external voltage,
the output will turn off and an error message will
be displayed. The overload must first be removed
before the output can be turned on again with
output command.
Using the Apply command automatically sets the
front panel output to on.
Syntax OUTPut {OFF|ON}
Example OUTP ON
Turns the output on.
Query Syntax OUTPut?
Return Parameter 1
0
ON
OFF
Example OUTP?
1
The output is currently on.
OUTPut:LOAD
Source Specific
Command
Description Sets or queries the output termination. Two
impedance settings can be chosen, DEFault (50Ω)
and INFinity (high impedance >10 kΩ).
The output termination is to be used as a reference
only. If the output termination is set 50Ω but the
actual load impedance is not 50Ω, then the
amplitude and offset will not be correct.
Note If the amplitude has been set and the output
termination is changed from 50Ω to high
impedance, the amplitude will double. Changing