GW Instek AFG-3000 Series - Manual (Page 111)

MODULATION
111
Frequency – Ramp 2mHz~1MHz
Default 1kHz
Note Waveform frequency and burst period are not the
same. The burst period is the time between the
bursts in N-Cycle mode.
Burst Cycle/Burst Count
The burst cycle (burst count) is used to define the number of cycles
that are output for a burst waveform. Burst cycle is only used with
N-cycle mode (internal, external or manual source). The default
burst cycle is 1.
Panel Operation 1. Press the Burst key.
2. Press F1 (N Cycle).
3. Press F1 (Cycles).
4. The Cycles parameter will become highlighted
in the Waveform Display area.