GW Instek AFG-3000 Series - Manual (Page 208)

AFG-3000 Series User Manual
208
Parameter 500μHz~50MHz
< amplitude > 10mV~10V (50Ω)
0~4.99V (50Ω)
Example SOUR1:APPL:PULS 1KHZ,MIN,MAX
Sets frequency to 1kHz and sets the amplitude to
minimum and the and offset to the maximum.
SOURce[1]:APPLy:NOISe
Source Specific
Command
Description Outputs Gaussian noise with a 50 MHz
bandwidth. Amplitude and offset can also be set.
Note Frequency cannot be used with the noise function;
however a value (or DEFault) must be specified.
The frequency is remembered for the next function
used.
Syntax SOURce[1]:APPLy:NOISe [
[, [,] ]]
Parameter Not applicable
< amplitude > 10mV~10V (50Ω)
0~4.99V (50Ω)
Example SOUR1:APPL:NOIS DEF, 3.0, 1.0
Sets the amplitude to 3 volts with an offset of 1
volt.
SOURce[1]:APPLy:TRIangle
Source Specific
Command
Description Outputs a triangle wave from the selected channel
when the command has executed. Frequency,
amplitude and offset can also be set.
Syntax SOURce[1]:APPLy:TRIangle [
[, [,] ]]
Parameter 1μHz~1MHz
< amplitude > 10mV~10V (50Ω)