GW Instek AFG-3000 Series - Manual (Page 106)

AFG-3000 Series User Manual
106
Note Using the Internal source will produce a
continuous sweep using the sweep time settings.
With an external source, a sweep is output each
time a trigger pulse (TTL) is received from the
Trigger INPUT terminal on the rear panel.
The trigger period must be equal to or greater than
the sweep time plus 1ms.
5. If manual is selected, press
F1 (Trigger) to manually
start each sweep.
Trigger Output
For sweep and burst mode, a trigger out signal can be output from
the Trig Out terminal on the rear panel. By default the trigger out
signal will output a rising edge TTL square wave at the beginning of
a sweep. The signal can also be set to falling edge.
Panel Operation 1. Press the SWEEP key.
2. Press F6 (More).
3. Press F4 (TRIG out).